BCD ("Binary-Coded Decimal"), also called alphanumeric BCD, alphameric BCD, BCD Interchange Code, or BCDIC, is a family of representations of numerals, uppercase Latin letters, and some special and control characters as six-bit character codes.
Unlike later encodings such as ASCII, BCD codes were not standardized. Different computer manufacturers, and even different product lines from the same manufacturer, often had their own variants, and sometimes included unique characters. Other six-bit encodings with completely different mappings, such as some FIELDATA variants or Transcode, are sometimes incorrectly termed BCD.
Many variants of BCD encode the characters '0' through '9' as the corresponding binary values.
Technically, binary-coded decimal describes the encoding of decimal numbers where each decimal digit is represented by a fixed number of bits, usually four.
With the introduction of the IBM card in 1928, IBM created a code capable of representing alphanumeric information, later adopted by other manufacturers. This code represents the numbers 0-9 by a single punch, and uses multiple punches for upper-case letters and special characters. A letter has two punches (zone [12,11,0] + digit [1–9]); most special characters have two or three punches (zone [12,11,0,or none] + digit [2–7] + 8).
The BCD code is the adaptation of the punched card code to a six-bit binary code by encoding the digit rows (nine rows, plus unpunched) into the low four bits, and the zone rows (three rows, plus unpunched) into the high two rows. The digit zero (a single punch in row 0) is usually handled specially in some way, and the digit code was extended to values 10 through 15 by combining a digit in the range 2–7 with a punch in row 8. IBM applied the terms binary-coded decimal and BCD to the variations of BCD alphamerics used in most early IBM computers, including the IBM 1620, IBM 1400 series, and non-Decimal Architecture members of the IBM 700/7000 series.