M3 Trench Knife
| M3 fighting knife | |
|---|---|
| Type | Fighting knife |
| Place of origin | United States |
| Service history | |
| In service | 1943–1950s |
| Used by | US Military |
| Wars | |
| Production history | |
| Designed | 1943 |
| Manufacturer |
|
| Produced | 1943-1944 |
| No. built | 2,590,247 |
| Variants |
|
| Specifications | |
| Length | 11.75 in (29.8 cm) |
| Blade length | 6.75 in (17.1 cm) |
|
|
|
| Blade type | Spear Point |
| Scabbard/sheath | M6, M8 & M8A1 |
The M3 fighting knife or M3 trench knife was an American military combat knife first issued in March 1943. The M3 was originally designated for issue to soldiers not otherwise equipped with a bayonet. However, it was particularly designed for use by elite or 'shock' forces in need of a close-combat knife such as airborne troops and Army Rangers, and these units received priority for the M3 at the start of production. As more M3 knives became available in 1943 and 1944, the knife was issued to other soldiers such as Army Air Corps crewmen and soldiers not otherwise equipped with a bayonet, including soldiers issued the M1 Carbine or submachine gun.
The M3 trench knife was developed as a replacement for the World War I-era U.S. Mark I trench knife, primarily to conserve strategic metal resources. The M3 would also replace the Fairbairn–Sykes fighting knife or OSS dagger in U.S. service in 1944. The M3 itself was discontinued in August 1944, after the M1 Carbine was modified to accept a knife-type bayonet. The M3's blade and handle design were incorporated into new M4 bayonet.
Designed for rapid production using a minimum of strategic metals and machine processes, the M3 trench knife used a relatively narrow 6.75-inch bayonet-style spear-point blade with a sharpened 3.5-inch secondary edge. The blade was made of carbon steel, and was either blued or parkerized. Production of the grooved leather handle was later simplified by forming the grip of stacked leather washers that were shaped by turning on a lathe, then polished and lacquered. The steel crossguard had an angular bend at one end to facilitate a thumb rest.
The M3 was developed as a replacement for the World War I-era U.S. Mark I trench knife, primarily to conserve strategic metal resources. The prototype for what would become the M3 was evaluated in December 1942 by the civilian board of directors of the Smaller War Plants Corporation Board (SWPC) against another competing design, the US Marine Corps' KA-BAR fighting utility knife. However, while the specified priority steel supplies for both knives were available, the M3's lower production cost compared to that of the KA-BAR convinced the SWPC board of directors to approve the M3 prototype for quantity production.
...
Wikipedia